Amplifier Warm-Up Time; System For Protecting The Amplifier And Speakers Against Damage; Protection Of The Natural Environment - Soundastic Reference Installation Und Betriebsanleitung

VI. Amplifier warm-up time
During the production process, the amplifier undergoes
the preliminary break-in process after which the repe-
ated parameter inspection is carried out.
The complete break-in process takes place at the end user, after
about 1-2 weeks of use. If we move the amplifier to the another
user, the break-in process will be significantly shorter: in general,
0.5-1 hour will be enough.
VII. System for protecting the amplifier
and speakers against damage
In order to protect the amplifier and speakers, mainly
tweeters, the amplifier is equipped with 2 types of safe-
guard measures:
1. When you switch the speaker wires during music playback (not
recommended), short circuit of wires or output terminals can
occur. The protection system will disconnect the speakers for
about 2 seconds. Do not test the safeguard system as this can
lead to failures not covered by the guarantee.
2. In case of exceeding the maximum power of the amplifier, hi-
gher harmonic distortions (clipping) occur that cause damage,
in the first instance, of the twitters. In such a situation, the am-
plifier will disconnect the speakers for a period of about 2 se-
conds; this requires immediate turning down using the Volume
knob or the remote control.
18
J
VIII. Protection of the natural environment
For the sake of the natural environment, please remem-
ber that damaged amplifiers should be sent to speciali-
sed companies dealing in utilisation of electronic devi-
ces. Dispose of used batteries from the remote control
in special containers.