Uzin Utz WOLFF EXTRO 2-Stripper Originalbetriebsanleitung Seite 17

Measurements determined in accordance with
EN 60745
The A-rated sound pressure level of the machine is
normally
Sound pressure level .....................dB(A)
Sound power level..........................dB(A)
Margin of error ...............................K=dB
Attention
Wear hearing protection!
Overall vibration values
(vector sum of three directions)
determined in accordance with EN 60745:
Vibration emission level .................ah =
Margin of error .................................K =
3.0 Preparing the machine
3.1 Installation Handel fig. E
► Put the handle into the bracket and fix wit bolts and
thumb nut (3).
► Connect the plug of motor and handle.
► Disasamble in other direction.
3.2 Adjusting the handle angle fig. E
The angle oft the handle can be fixed into four positions.
Loosen and remover bolt (3) and choose one of the four
positions to your comfortable angle.
3.3 Adjusting the handle height fig. E
The height of the handle can be adjusted to adapt the ma-
chine to the stature of the operator. To adjust the inclina-
tion, loosen the thumb screw (1), pull the adjustment bolt
(2) and adjust as you like. Thighten the thumb screw (1)
after adjustment.
3.4 Changing the blade fig. A
► Disconnect the power supply before changing the
blade.
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 |
All manuals and user guides at all-guides.com
► Use work gloves for your own safety tip the machi-
92
105
+/- 1.5 dB ► Very sharp blade! You may cause injury without
► Secure the tipped machine from tilting over
► Clean and loosen the screws fig. A (2) of the blade
10 m/s² ► Set the wrench at a position opposite to the blade
+/- 1.5 m/s²
► Replace the blade.
► Make sure that the blade fits in exactly into the
4.0 Use
4.1 Preparations fig. D
► Before starting work, cut the floor covering into
► To begin, cut one stripe crosswise. Then lift the floor
► We recommend to cut the first strip at right angles to
www.wolff-tools.de
neput on the blade protection (enclosed in the
tools set)
Attention
Knives get very hot when working,
do not grasp them before they have
cooled down.
using the blade protection!
mounting,
to avoid injury.
support.
On normal and hard subfloors the bevel of the
blade should show upwards fig. C (1), on soft
subfloors (e.g. chipboards) the bevel should
show downwards (2).
The EXTRO-Stripper removes any bonded floor
coverings in stripes.
stripes of about 35 cm (12 inch).
You cannot work faster if you cut wider stripes.
slightly in order to get the blade underneath it.
the main working direction. By so doing access to the
adjacent strips is made easier.
Cut the strips smaller if the floor covering is bon-
ded very ecurely, e.g. with an epoxy adhesive.
EN
17