Red Bull SPECT STRIVE Bedienungsanleitung Seite 4

Thank you for choosing the STRIVE goggle from Red Bull SPECT
Eyewear. The STRIVE goggle has been developed to get you
the best possible eye protection for motorsport activities.
Please read the following instructions carefully and keep this
brochure in a safe place at your disposal.
SAFETY
The STRIVE goggle can be used for all kind of motorcycle
and moped activities except offcial races and competitions.
The goggle protects from wind, solar radiation, and impacts
from water or mud.
It is not a safety goggle. Consequently, the lenses do not
offer any protection against hard or pointed objects, nor
does the goggle prevent injuries due to falling or prevent
traumas caused by high-energy impacts.
The goggle is not suitable for direct viewing of the sun (e.g.
during eclipses) and for exposure to UV radiation produced
by artificial means (e.g. suntan lamps).
In order to avoid the goggle lens from fogging up, foam co-
vered air vents around the frame provide adequate venting.
The frame is made out of TPU material which retains its
softness in all ambient climate conditions.
Only lenses with filter class 0 are suitable for use in low light
conditions.
4
INSPECTION
Carefully check the goggle before every use and after every
fall for any damage.
The lens must not be split, the strap must be securely faste-
ned to the frame and the frame should not have any cracks.
Make sure the lens is fitted securely into the frame prior to use.
To guarantee an optimal fit, adjust the strap to the size of
your helmet.
In case of damages (e.g. lens scratches, loose strap), change
the lens, replace the defective part or, if necessary, the entire
goggle.
Damaged goggles shall no longer be used.
Only use original spare parts and accessories as offered in
the offcial Red Bull SPECT Eyewear commercial catalogues.
It is suggested to replace the goggle after two years of use.
Its protective capacity, due to materials ageing, decreases
as time goes by.
The Michael Pachleitner Group is not responsible in case of
wrong use of original replacement parts.
MAINTENANCE
In order to prevent scratching off the lens always wash of any
dirt and dust particles from the outside of the lens using luke
warm water.