Waterproof World Wide Warranty; Ec Type Examination And Suit Type; Checking The Suit - WATERPROOF DIVING INTERNATIONAL W1 Benutzerhandbuch

Waterproof World Wide Warranty

Waterproof warrants products purchased from a Waterproof dealer against
defects in materials and workmanship to the original purchaser for a period of
two years. The purchase must be verified by a valid sales receipt. The warranty
applies to common scuba diving and does not cover damage due to abuse,
neglect, improper usage, unauthorized repair or modifications, lack of proper
maintenance or normal wear and tear. Lack of proper maintenance will cause
abnormal deterioration.
Warranty claims should be submitted to the dealer where the product was
purchased. The dealer delivers the product to Waterproof together with a copy
of the purchase receipt and a detailed described claim. The sender is responsible
for the shipping cost. Waterproof will, if it is a valid warranty claim, repair or
replace the product at its own discretion without charge. If the defect product
is unavailable Waterproof reserves the right to replace it by a similar product of
comparable value. The defect product that has been replaced is the property of
Waterproof. After repair/replacement the product will be sent back to the dealer
free of charge. If the product is not found to be covered by this program
Waterproof reserves the right to charge a handling fee.

EC type examination and suit type

The suits herein described are certified according to the Regulation (EU)
2016/425 PPE and exceed the minimum requirements of the EN14225-1:2017.
The risks identified in the risk assessment are presented on the basis of the
above warnings.
CE
Waterproof guarantees that the designated products comply with the
requirements and that Waterproof meets its obligations concerning the
Regulation (EU) 2016/425 PPE. Link to Regulation (EU):
eur-lex.europa.eu/legal-content/EN/TXT/?uri=CELEX:32016R0425
EN14225-1:2017
The below suits have been tested by an independent institution in accordance
with the requirements of European standards EN14225-1:2017.
8
You can request a copy of these standards from your national
standards organization.
The EC type assessment was handled by:
RINA SERVICES SPA (No. 0474)
Via Corsica, 12 - 16128 Genova, Italy
Tel. +39 010 53851
Fax. +39 010 5351000
For suits:
W1 5mm, W1 7mm, W4 5mm, W4 7mm , W5, W7 5mm, W7 7mm, W8 5mm,
W8 7mm, W50, W80, SD Combat, SD4
Link to declaration of conformity's: www.waterproof.eu
Assembly
Your suit will be delivered fully assembled.
Checking the suit before diving
Inspect the suit for damage.
• Remove any rings, watches and jewelry with sharp points.
• Do not wear anything that could damage the suit.
• Ensure that the zipper is properly lubricated.
• Pulling the zipper over an obstruction can break the zipper.
• Make sure the zipper is completely closed before you go into the water.
Checking the suit after diving
• After a dive, use fresh water to rinse your suit. Clean your zipper of debris.
• Dry your suit well, both inside and outside.
WETSUIT_ENG_DE_FR_20200408 WETSUIT_ENG_DE_FR_20200408
If the suit is damaged, do not dive with it.
The suit must be checked by an authorized service station
and repaired if necessary.
9