Parameter Setting - Poollux Inverter Style Benutzer- Und Wartungshandbuch

Code Condition
d0 IPM mould temperature
d1 Inlet water temp.
d2 Outlet water temp.
d3 Ambient temp.
d4 Frequency limitation code
d5 Piping temp.
d6 Gas exhaust temperature
d7 Step of EEV
d8 Compressor running frequency
d9 Compressor current
d10 Current fan speed
d11 Error code for last time
6.2.2 Temp & COP curve
Click to check the Temp & COP curve. Only after the heat pump runs 4 minutes under heating mode, COP curve
can be showed;

6.2.3 Parameter setting

There are also four interfaces (Parameter A-D) as below pictures shows. Page up or down same as parameter query.
Scope
0-120℃
-9℃～99℃
-9℃～99℃
-30℃～70℃
0,1,2,4,8,16
-30℃～70℃
0℃～C5℃ (125℃)
0～99
0～99Hz
0～30A
0-1200 （rpm）
All error code
17
Remark
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value
N*5
Real testing value
Real testing value
Real testing value