Werbung
GB: Instructions - please observe the following warnings!
Dear Customer,
We cordially congratulate you for buying new furniture. Please note the following cautions, which are
necessary for the proper use of new furniture.
The attached mounting instructions need to be read carefully and observed.
We assume no liability for errors resulting from improper installation!
Place the furniture (part of the furniture) on a soft base to prevent scratches!
Please use the fitting, respectively individual parts according to the accompanying mounting
procedures! The flawless function of the furniture is guaranteed only in vertical and horizontal
installation. The area under the furniture should be so balanced that the furniture is secure!
If it is assumed to mount the furniture on the wall, it is necessary to verify in advance the sufficient load
capacity and composition of the wall.
No wall plugs are supplied for wall mounting as they have to be specially choosen suitable for the
respective wall condition (load capacity). For masonry that deviates from solid walls (for example,
concrete and solid masonry), which requires special fasteners, we recommend consulting the
specialist trade if necessary. Elements with tilting moment are to be connected to the building wall for
safety reasons. The anti-tilt bracket is supplied with the corresponding elements.
All drawers and runner systems drawers have to be secured against falling out. Doors are preset
adjusted at the factory, but may, at local conditions, be rebalanced / adjusted at the customer. Do not
open the doors more than 90 °, otherwise the door or the fittings will be damaged.
All screws as well as supporting fasteners should be tightened after 5 to 6 weeks in order to guarantee
the permanent stability of the furniture!
All electrical installations are manufactured in accordance with applicable standards and regulations.
! Observe the enclosed assembly instructions - light guide! The light output used is indicated on the
lamp socket. If the max. number of watts is exceed, it threatens overloading and the risk of fire. Avoid
covering the lamp or heat accumulation due to fire hazards
When inserting or removing the shelves, all types of material, please do not tilt. This can lead to
damage to the furniture elements. Sharp-edged or pointed objects, as well as hard touchdown can
lead to damage to the shelf or to glass breakage in the glass shelf.
If a part is missing or damaged, please tick this clearly on the assembly instructions or give details of the
type and part designation. Also, provide the serial number and date from the packaging and / or the back
panel. This information will then be sent to your contract partner.
MAINTANCE:
Processing and quality of the material do not require special maintenance or expensive care products.
Do not use solvents and abrasive cleaners.
Only clean the furniture with a duster or damp cloth
NOTE:
All front panels are protected with a protective foil film, which is only removed after a successful assembly by the
customer. After removing the foil, the high-gloss surface may only be cleaned after 72 hours, see care.
-5-
Werbung
