To Clean The Product; Technical Data - Hamron 619231 Bedienungsanleitung

Note! Make sure that the pressure plate is above the nut on the inner
eye bolt.
5
Adjust the position of the product until the roof rack tubes are
centered (B) and 600 mm (C) away from each other. (Figure 9)
6
Turn the nut (D) and the lock knob (E) until the pressure plate and the
roof rack tube are parallel. Tighten the nut and the lock knob fully.
(Figure 10–11)
7
Make sure that the lock knob is in the correct position when you have
tightened it. (Figure 12)
8
Push down the inner protective cover (F) and install the outer
protective cover (G). (Figure 13)
9
Lock the outer protective cover with the key. (Figure 14)
10
Pull on the product to make sure that it is fully installed to the roof
rails on the vehicle. Tighten the lock knob and the nut if it is
necessary.
11
Remove the product in the opposite sequence.
4 Operation
4.1 To use the product
● Make sure that the load is centered on the roof of the vehicle.
(Figure 15-16)
5 Maintenance

5.1 To clean the product

Caution! Do not use solvents or caustic solutions to clean the
product.
Clean the product with water and wipe the product with a clean cloth until
it is dry.
6 Storage
● Keep the product in its storage case in a dry environment.
7 Disposal
7.1 To discard the product
● Make sure that you follow local regulations when you discard the
product. Do not burn the product.

8 Technical data

Technical data
Maximum load
Dimensions (without load)
2022_001
50 kg
1360 mm
13