Mounting And Operation; Working Advice - Bosch AXT Rapid 2000 Originalbetriebsanleitung

OBJ_BUCH-2230-001.book Page 14 Wednesday, October 22, 2014 9:25 AM
14 | English

Mounting and Operation

Action
Delivery Scope
Mounting wheels and undercarriage
Mounting the collecting bag and base
unit bearn
Connecting the Extension Lead
Starting

Working Advice

Stopping
Blade Maintenance
Maintenance, Cleaning and Storage
Selecting Accessories
Working Advice
Starting
To start your Shredder, rotate the On/Off switch from posi-
tion "0" to position "II". Allow machine to start and release
switch, which will return to position "I" (the normal run posi-
tion).
Note: The machine will not start if the On/Off switch is pushed
in slightly, whilst being rotated.
As a safety feature the machine will not start unless the hop-
per securing knob is fully tightened.
Troubleshooting
The following chart lists problem symptoms, possible causes and corrective action, if your garden product does not operate
properly. If these do not identify and correct the problem, contact your service agent.
 Warning! Switch off, remove plug from mains before adjusting, cleaning or if cable is cut, damaged or entangled.
Problem Possible Cause
Machine fails to operate Switch fails to operate
Securing knob has not been fully tightened Tighten securing knob
Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Motor protector has activated
Power supply interrupted
On/Off switch returns to position "0"
Machine functions Extension cable damaged
intermittently
Internal wiring of machine damaged
Motor protector has activated
On/Off switch returns to position "0"
F 016 L81 148 | (22.10.14)
Restarting Protection
A mains failure causes machine to switch off. The machine
Figure Page
cannot restart on its own when the power returns.
1 201
Overload Protection
2 201
Overloading (e. g. blocking up of the cutter) can lead to a
standstill of the machine after a few seconds. After a short pe-
3 202
riod, the machine can be switched on again. If the machine
4 202
blocks again turn it off.
5 203
Remove blockage and restart.
6 203
Advice on Shredding
7 204
Branches become harder to shred depending on the type, age
8 204
and dryness of the wood.
9 205
For best results, shred fresh branches soon after they have
10 205
been cut.
Soft garden waste should be shredded in smaller loads, par-
ticularly when wet. Any blockages can be avoided by intermit-
tently shredding branches.
Blade Maintenance
 Stop and remove plug from the power supply.
The blade has a double sided cutting edge.
When the cutting edges become blunt, the blade can be
turned over. The blade bolt may only be reused once, do not
reuse or use a non approved blade bolt. When both sides are
blunt replace the blade.
When fitting a new blade, discard old bolt and only use a
Bosch approved bolt, supplied.
Corrective Action
Do not push On/Off switch while it is being rotated
Turn power on
Use another socket
Inspect cable, replace if damaged
Replacse/restart
Follow "Overload Protection" procedure
Follow "Overload Protection" procedure
Allow machine to cool then follow "Overload Protec-
tion" procedure
Check mains cable and have it replaced, if required
Contact Service Agent
Follow "Overload Protection" procedure
Allow machine to cool then follow "Overload Protec-
tion" procedure
Bosch Power Tools