Starting And Stopping; Removing Blockage - Bosch AXT RAPID 180 Bedienungsanleitung

Products sold in GB only: Your mower is fitted with
an approved 13 A (BS 1363/A) electric plug and is
protected by a 13 A fuse (ASTA Approved to
BS 1362).
If the fitted plug is not suitable for your socket out-
lets, it should be cut off and an appropriate plug fit-
ted in its place.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be inserted
into a 13 A socket elsewhere.
Assembly
Remove the machine from the package.
A
Mount the wheels and the undercarriage.
B
Fit the Allen key 12 as shown.
E

Starting and Stopping

C
The blade continues to rotate for a few
seconds after the machine is switched off.
Allow the motor/blade to stop rotating be-
fore switching "on" again.
Do not rapidly switch off and on.
Starting:
To start your Shredder, rotate the On/Off switch 2
from position "0" to position "II". Allow machine to
start and release switch, which will return to posi-
tion "I" (the normal run position).
Important note: The machine will not start if the
On/Off switch 2 is pushed in slightly, whilst be-
ing rotated.
As a safety feature the machine will not start unless
the hopper securing knob 3 is fully tightened.
Stopping:
Rotate the On/Off switch 2 to position "0".
Note: The blade will stop automatically before the
cover 11 can be removed.
Emergency Stop:
Press the On/Off switch 2.
Restart Protection
After a mains failure, or if the product cuts out due to
overloads, the machine cannot restart on its own
when the power returns or when protector resets.
14 • F 016 L70 340 • TMS • 20.10.05
To restart the machine:
Set the On/Off switch 2 to "0".
Rotate the On/Off switch 2 to position "II", al-
low the machine to start and release the
switch. It will now move to position "I" (the nor-
mal run position).
Important note: The machine will not start if the
On/Off switch 2 is pushed in slightly, whilst be-
ing rotated.
Overload Protection
Overloading (e. g. blocking up of the cutter) can lead
to a standstill of the machine after a few seconds. Af-
ter a short period, the machine can be switched on
again. If the machine blocks again turn it off.
Remove blockage (see "Removing blockage"), and
restart.
Shredding
In order to collect the shredded material, fasten the
carrying straps of the collecting bag 7 (accessory) to
the two hooks 9.
Feed the material to be shredded through the feed
intake.
Longer material standing out from the ma-
chine could lash out when being cut!
Small pieces of shredded material may be
ejected from the feed intake. Ensure eye
protection, protective gloves and ear pro-
tection are used when using the machine.
Only insert as much material so that the feed in-
take 1 will not be blocked up.
Do not fill soft waste such as kitchen rubbish into the
shredder but compost directly.
Take care that the shredded material can fall freely
from the discharge chute 8 – danger of backing up!
The ventilation slots 5 must not be covered by the
collecting bag or the shredded material.
Avoid blocking the discharge chute 8 with shredded
material as this could result in kickback of material
through the feed intake opening.

Removing Blockage

Stop and remove plug from the power sup-
ply.
After fully unscrewing the securing knob 3, remove
cover 11 and clean the blade area. If debris is com-
pacted in the blade area, remove with a wooden or
plastic implement. Also clean the discharge chute 8
of any debris.
English - 3