Chronograph Models - Michele RONDA 703 Bedienungsanleitung

CHRONOGRAPH MODELS

(RONDA 5030�D, 5040�D, 5050�B)
5040�D
Pusher A
I II III
Hour
Hand
Minute Hand
Second
Hand
Pusher B
Date Indicator
Setting the Time
1. Pull crown out to position III (the watch stops).
2. Turn crown until you reach correct time.
3. Push crown back into position I.
Setting the Date
1. Pull crown out to position II (the watch continues to run).
2. Turn crown until yesterday's date appears.
3. Pull crown out to position III (the watch stops).
4. Turn crown until the correct date appears.
*NOTE: When the correct date first appears, your watch is set at midnight.
5. Continue to turn crown until the correct time appears.
6. Push crown back into position I.
18
5050�B
Crown
(Position I, II, III)
Date Indicator
Chronograph
• The minute counter measures 30 minutes per rotation.
• The center stop-second measures 60 seconds per rotation.
Center Stop-second
I II III
5040�D: 30 Minute Counter
5050�B: 30 Minute Counter
and Hour Counter
1/10 Seconds Counter
PLEASE NOTE:
Before using the chronograph functions, please ensure that:
- The crown is in position I (= normal position)
- The two chronograph hands are precisely at zero position following activation of
pusher B. Should this not be the case, the positions of the hands must be adjusted.
(See chapter entitled "Adjusting the chronograph hands to zero").
Chronograph: Basic Function
(Start/ Stop/ Reset)
1. Press pusher A to start the center stop-second hand.
2. To stop the timing, press pusher A again.
3. To reset the 3 chronograph hands to zero positioning, press pusher B.
Seconds Counter
Pusher A
I II III
Crown
(Position I, II, III)
Pusher B
19