hillvert HT-LM-53A Bedienungsanleitung Seite 41

IMPORTANT: The device runs on fuel alone - do not use any fuel-oil mixtures! Always
use fresh fuel, never store fuel in the tank for more than one month.
ATTENTION: installation of accessories, adjustment, cleaning, maintenance, refilling
with fuel/oil should be done only when the device is switched off and when the
knives stop completely. For additional safety, remove the ignition wire pipe from
the spark plug.
MOWING HEIGHT ADJUSTMENT
The height of cut adjustment lever is located on the right side of the machine (when
viewed from the operator's position), next to the rear wheel - there are 7 settings
to choose from, ranging from 25-75 mm. To select a particular setting, press/swivel
the lever in the direction of the wheel and thereby set it up or down in one of the
pawls - all 4 wheels will adjust their height simultaneously.