Rx Setpoint: [650 Mv]; Rx P Range: [20 Mv]; Minimum Alarm (↓): [550 Mv]; Maximum Alarm (↑): [750 Mv] - swim-tec CL2 Deluxe WiFi Salz 1,6 l/h Bedienungsanleitung

5.2 Rx setpoint: [650 mV]

The disassociation curve of the chlorine value must be observed in accordance with the
pH
value.
100
80
60
40
20
0
pH 6
The system regulates and doses chlorine via the Redox potential. First set the pH value
in the pool water. Then introduce the required quantity of chlorine to the pool water.
We recommend 0.3-0.6 mg/l measured using the DPD method. Read off the measured
Redox voltage on the control unit and set the setpoint in accordance with the read value.
Since every water has different Redox values (even with the same chlorine
concentration) we are not able to give a basic setting. It will thus not necessarily
correspond to the factory setting of the setpoint. After about 2-3 weeks or every refill,
the setpoint must be compared with the desired chlorine value and adjusted as required
since the effective Redox value is only established when the system is under operation.
If the actual value undercuts the setpoint, the system automatically activates the salt
electrolysis until the setpoint is achieved. The electrolysis unit then switches off.

5.3 Rx p range: [20 mV]

The numeric value gives the proportional range and thus the regulation slope. The usual
value is 20 mV.
Meaning: The p-range can be used to change the initial value at which the unit starts
the dosing process. With a p-range of 20 mV and a setpoint of 650 mV, the system
switches the electrolyser on at a redox potential of 630 mV. After reaching the setpoint,
the electrolyser is switched off again.
5.4 Minimum alarm (↓): [550 mV]
Minimum alarm value which, when undercut, triggers an alarm.
5.5 Maximum alarm (↑): [750 mV]
Maximum alarm value which, when exceeded, will trigger an alarm.
HCLO
pH 6,5 pH 7,0 pH 7,5 pH 8,0 pH 8,5 pH 9,0
43