Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Insert the lightly greased contact shoe into the guide to the desired position.
The contact shoe can be used in three positions.
6. Check that the contact shoe has engaged.
7. Insert the saw blade. → page 23
8
Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery/batteries.
▶ Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.
▶ Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9
Troubleshooting
If a problem occurs, always observe the charge-status and fault indicator of the battery. See the section
headed Status indicators of the Liion battery.
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
Product does not develop full
power.
The battery does not engage
with an audible click.
Product does not start.
*2243124*
Possible cause
The control switch is not fully
pressed.
Battery is discharged.
The retaining lugs on the battery
are dirty.
The battery is not correctly in-
serted.
Battery defective.
Damage to the product
2243124
Action to be taken
▶ Press the control switch fully.
▶ Change the battery and charge
the empty battery.
▶ Clean the retaining lug and refit
the battery.
▶ Push the battery in until it
engages with a click.
▶ Contact Hilti Service.
▶ Have the product repaired by
Hilti Service.
English
25
Werbung
Inhaltsverzeichnis
