B2.4 Warm Up Cycle; B2.5 Touch Screen; B2.6 Basic Settings - Nanosonics trophon 2 Bedienungsanleitung

B2.4 Warm up Cycle

1. The warm up cycle prepares the trophon2 device for operation and will begin automatically when
the device is powered on.
2. The screen message will indicate when the trophon2 device is ready for use. Follow the onscreen
instructions.

B2.5 Touch Screen

The trophon2 device is operated using the touch screen User Interface (UI).
NOTE: The UI can be operated with gloves.
Cleaning the Touch Screen of the trophon2 Device
The screen can be wiped clean using a soft, nonabrasive low lint or lint-free cloth or wipe.

B2.6 Basic Settings

In general, to access settings on the trophon2 device:
1. Select Menu

2. Select the required setting and follow the onscreen prompts.
The available settings are:
Sleep timer:
The default inactive period until the trophon2 device enters sleep mode is two hours, which can be
adjusted in this setting or switched off. For details, see C3.8 Sleep Mode.
Language
Choose appropriate language for your region.
Date, Time
You can set the time and date manually.
To set the date, select Menu
To set the time, select Menu
Within these menus, the following settings require inputs: Region, Timezone, Date, Date Format, Time,
Time Format. It is important to set these settings accurately to ensure the accuracy of the disinfection
traceability records.
The trophon2 device will ask you to set the timezone, and then the time. The device will update the time
when daylight saving time (DST) starts and ends according to the timezone set.
NOTE: It is important to ensure the correct timezone is set in order for the DST to update correctly.
If you are running trophon2 Software Version 1.3.10.2 or later, you can configure the device to
automatically synchronise date and time to a time server using Network Time Protocol (NTP). To enable
this:
1. Consult your facility's IT administrator or network parameters expert and obtain network settings
for a time server.
2. Be sure your trophon2 device is connected to the Internet, normally via your local network. See
Network definition below.
3. Select Menu

Set the timezone and select NEXT.
NOTE: It is important to ensure the correct timezone is set in order for the DST to update correctly.
Settings.
Settings
 
Settings Time.
 
Settings Time.

L03082 1.0 09/2021
Date.
17