Clean Air Optima CA-704 Gebrauchsanweisung Seite 6

Control panel / Operation instruction
Power
Press the Power Button to activate the device
Press the Power Button again, the device turns off.
MODE
Press the MODE Button to select one of four desired programs:
1. Smart Mode: Desired humidity set to 55% relative humidity and the fan is auto-
matically adjusted depending on the current humidity level.
The desired humidity can not be changed in this mode.
2. High/ Low Mode: Select the Fan speed, the desired humidity can then be
adjusted using the + and - buttons.
3. Fan Mode: Continuous air purification (low fan speed, no dehumidifying
function).
Air purification
If the desired humidity level is reached at a constant level, you can switch to program
3 to use the device for continuous air purification.
increments of 5%). Once you select your desired humidity level, simply stop pressing
the +or - button and your humidity level will be set.
When the humidity level in the room reaches the set humidity level, the device will
stop dehumidifying.
When the room's actual humidity level increases again above your set humidity level,
then the device will start dehumidifying and air purifying again.
If the relative humidity is set to 35%, the compressor will only stop when the water
tank is full.
UV and ION
After pressing once, the UV function is switched on.
After pressing twice, the ION function is switched on.
After pressing three times, the UV and ION functions are switched on.
After pressing four times, the UV and ION functions are switched off.
UV sterilization technology is accepted for more than fifty years and it has been
proven that it can considerably reduce the number of bacteria and polluting
substances in the air safely.
6
Humidity Button
By pressing the up or down button, you can select the desired humidity
level. The required humidity level is displayed (from 35% to 80% in