Suunto Tank POD Kurzanleitung Seite 8

INSTALLATION
TYPE A
For installation directly to first-stage high pressure port
1. Insert the Type A flow restrictor into the transmitter.
2. Attach the transmitter to the first-stage high pressure port.
3. Slowly and steadily open the pressure valve. Look away as your gear is
pressurized.
4. Wait for green LED on the transmitter to flash.
5. Enter dive mode on your dive computer.
6. Hold your dive computer close to the transmitter. The dive computer displays the
selected code number and then starts displaying the transmitted pressure.
7. Check that the wireless transmission icon is active on your dive computer to
confirm connection.
TYPE B
For installation to high pressure hose extension to first-stage high pressure port
1. Insert the smooth end of Type B flow restrictor into the transmitter. The grooved
end should remain visible.
2. Attach the high pressure hose extension to the first-stage high pressure port.
3. Attach the transmitter to the end of the high pressure hose extension, ensuring the
grooved end of the restrictor is inserted into the hose.
4. Slowly and steadily open the pressure valve. Look away as your gear is
pressurized.
5. Wait for green LED on the transmitter to flash.
6. Enter dive mode on your dive computer.
7. Hold your dive computer close to the transmitter. The dive computer displays the
selected code number and then starts displaying the transmitted pressure.
8. Check that the wireless transmission icon is active on your dive computer to
confirm connection.
NOTE: Older Transmitter devices do not have the LED.
8