Installation - Klarstein VINSIDER 24 Bedienungsanleitung

INSTALLATION

Befor Installation (Built-in)
• Remove all exterior and interior packing.
• Before connecting the Wine Cooler to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system caused by handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• The door on this appliance can be opened from either the left or the right side. The
unit is delivered with the door opening on the left side.
Installation
• The appliance is designed to be built-in the kitchen cabinets.
• The appliance should be positioned in a well-ventilated, dry room.
• Place your Wine Cooler on a position that is strong enough to support it when it is
fully loaded. To level your Wine Cooler, adjust the front leveling legs at the bottom
of the Wine Cooler.
• Locate the Wine Cooler away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extreme cold ambient temperatures
may also cause the unit not to perform properly.
• Plug the Wine Cooler into an exclusive, easily accessible plug socket. Any
questions concerning power and/ or earthing should be directed towards a
qualified electrician or an authorized products service centre.
• To prevent the appliance from heating up, ensure that an adequate ventilation gap
is retained and install a suitable thermal insulation panel. An adequate flow of air to
and from the cooling system must be ensured.
• The appliance must be installed to all electrical, plumbing, water and drain
connections in
Built-in Cabinet Instructions
The wine cooler door seals the installed unit almost completely, so an air vent must be
provided in the base of the housing. Warmed air must be conducted via the ventilation
shaft to the rear wall of the housing and then expelled upwards. The ventilation channels
should measure at least 200 square centimeters in cross-section.
1. Remove the door gasket on the side you wish to install the handle - you can see two
designated holes for handle installation.
2. Install the handle tightly as shown above with two screws, lock washers and flat
washers provided. WARN- ING: To ensure the proper functioning of the appliance,
air vents should never be blocked or covered.
EN
25