Intended Use - RED ROOSTER RRI-BS9H2 Betriebsanleitung

​ L ight up in red for one second.
A long beep for one second.
​ L ight up in green.
​ B links in yellow for five times.
Five short beeps
Light up in yellow for five seconds.
A long beep for five seconds
​ L ight up in blue.
​ B links in red for two times
​ B links in red for three times.
​ B links in red for four times
Left – Right rotation:
For left rotation: push the F/R button, blue light > tool is in left rotation. Push F/R button again for right rotation.
​ A utomatically switching back from left to right rotation: push the F/R button for 5 seconds until the blue LED blinks once, now the tool rotates one cycle in left direction and after stopping the tool
switches automatic to the right rotation. Deactivating: holding the F/R button again for 5 seconds until the blue LED blinks once.
RPM setting pistol model:
​ W ith the "Programmer" the rpm of the motor can be adjusted, see manual of the Programmer.
Maintenance:
Check the tool regularly for loose bolts/screws or parts.
In case of power loss: Have the tool repaired.
Only trained and qualified engineers are allowed to adjust or repair the tool.
In case of disposal of the tool, follow local regulations, so as much as possible can be recycled. Do not throw it in the normal waste bin.
The tool should be maintained regularly to minimize the noise emission and occurring vibration.​

Intended use:

The user or the user's employer shall assess the specific use that can be present as a result of each use.
Never use the tool otherwise than the tool is designed for and as explained in this manual.
Damages as a consequence of not following this manual, or caused by incorrect use or incorrect repairs, will never be covered by our warranty and we will have no responsibility for it. We reserve
the right for technical improvements, without prior notification.
This tool is designed for tightening processes on threaded fasteners, if used otherwise a risk assessment has to be made by the employer/user.
​ T he screw is refastened after fastening (NOK).
​ T he preset torque is reached and the tightening is
OK.
​ T he battery power becomes low
​ T he battery power is used up, the tool stops
immediately.
​ T he tool is in reverse operation
​ T he motor is too hot
​ T he motor has failed.
​ T he connector wire has failed.
​ T he screwing fastener must be performed again.
​ -
​ R eplace the battery with a fully charged one
​ R eplace the battery with a fully charged one.
​ -
​ R emove the battery and let the tool cool down, and
then reattach the battery. The tool can work properly
again.
​ S end to the service center.
​ S end to the service center.