Before Taking Into Use; Charging The Battery - RED ROOSTER RRI-BS9H2 Betriebsanleitung

EN
Brand : RED ROOSTER Industrial
Safety standard : EN ISO 11148-6
Drive : 1/4" Hex
Bolt capacity (mm) : 5
RPM : 300 - 800
Torque (Nm) : 2 - 9
Weight (kg) : 1,0
mm A : 203
mm B : 238
Vibration level (m/s²) : < 2,5
Sound level (dB(A)) : < 75
Battery voltage (Volt) : 20
Battery type Li-ion....(Ah) : 2,5 / 5,0

Before taking into use

Read and understand the contents of this manual before installing, operating, repairing, maintaining, changing accessories of this tool.
Only qualified and trained operators should install, adjust or use the tool.

Charging the battery

​ S lide the battery in the charger, this should go smoothly otherwise the alignment isn't correct or the battery / charger grooves are damaged. In that case check the battery and charger and replace
the damaged item, do not repair.
​ C ool down the charger when charging more than two battery packs consecutively.
Do not insert your fingers/ nails into contact hole, when holding charger or any other occasions.
​ P lace charger in a relatively cool and well-ventilated area.
​ P lug charger into the AC outlet. CAUTION: Ensure that the power source to be utilized conforms to the power requirement specified on the product nameplate.
​ I f the power lamp (red) does not light immediately or goes out soon after the charger is plugged in, consult an authorized dealer.
​ D uring charging, the charging lamp (green) will start flashing. When charging is completed, an internal electronic switch will automatically be triggered to prevent overcharging.
​ C harging will not start if the battery pack is warm. For example, immediately after heavy-duty operation. The yellow standby lamp will be flashing until the battery cools down.
​ O nce the battery is fully charged, the green lamp will be lit to indicate the gone into a trickle charge mode.
Mounting the battery:
​ R emoving the battery: