Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Issue
The product work but there is no
power at the power outlet for ac-
cessories.
The motor runs but there is poor
suction.
Dust blown from the exhaust.
The auto filter purge function
does not work.
The air compressor do not stop.
Transportation of the product
•
Make sure that the Longopac bag is empty before a
transportation.
•
Make sure that the Longopac bag is attached to the
product during transportation.
•
Use ramps or winches to lift the dust extractor to
make sure that movements are safe. Get aid if you
are not sure about how to lift heavy equipment.
•
Attach the product safely during transportation in
order to prevent transport damage and accidents.
Use the tie down lugs on both sides of the product.
•
Engage the locking caster safely on the wheels.
•
If possible, do the transportation of the product
during good weather conditions.
•
If possible, use a closed vehicle during
transportation of the product.
To set the product in transport position
Note:
The product can be lowered to make
transportation easier.
Note:
A gas spring hold the product in the top
position. The product can not fall down.
1883 - 001 - 01.06.2022
Cause
Unit not connected correctly.
Defective connection in the electrical cabinet.
The filter is clogged.
The cyclone is clogged.
Wrongly assembled or damaged filter system.
The filter is loose.
The filter is damaged.
The compessed air hose is damaged or loose.
The compessed air filter is clogged.
The compessed air filter is clogged.
Transportation, storage and disposal
1. Loosen the hose clamp and remove the hose.
Solution
Do a check of the connection.
Turn off the product and contact
a electrician.
Clean or replace the filter.
Use compressed air or a brush
to clean the cyclone parts.
Adjust or replace the filter.
Adjust or replace the filter.
Replace the filter.
Replace or fasten the com-
pessed air hose.
Clean or replace the filter.
Clean or replace the filter.
95
Werbung
Inhaltsverzeichnis
Fehlerbehebung
