Husqvarna DC 6000 Bedienungsanweisung Seite 93

To install a new Longopac dust bag
WARNING:
before you replace the Longopac dust bag.
1. Put the Longopac dust bag in the holder.
2. To attach the Longopac dust bag holder, twist the
Longopac dust bag holder until the pins engage in
the slots.
3. Pull the Longopac bag up from the holder and put it
around the container.
1883 - 001 - 01.06.2022
Always clean the prefilter
4. Tighten a strap around the Longopac dust bag and
the container to attach the bag correctly to the
container.
5. Pull the Longopac dust bag down on the outer side
of the bag holder.
6. Close the bottom of the Longopac dust bag with a
cable tie.
To discard a full Longopac bag and
prepare a new Longopac bag
WARNING:
caution, a full Longopac bag can be heavy.
Make sure that the cable ties are closed
correctly before you lift the Longopac bag.
Lift the Longopac bag with
93