Notes On Accessories - Fuxtec FX-MT152 Original Bedienungsanleitung

Original Bedienungsanleitung FUXTEC FX-MT152/-MT152E/-MT252_de_en_fr_ita_rev18

Notes on accessories

● Make sure that your product is only equipped with original accessories. Only use
original parts that are specified by the manufacturer. The use of any other
attachments or accessories may cause injury to the user and damage to the device.
● Clean the device thoroughly, especially the fuel tank and air filter. After using the
device, remove all fuel.
● If you approach a user of the device as a spectator, carefully attract his attention
and confirm that the user will stop the device. Please do not startle or distract the
user. Otherwise, you could cause an unsafe situation.
● Never touch the nylon cutting head or metal blade when the device is running. If it
is necessary to replace the guard or cutting tool, be sure that the device and cutting
tools have stopped.
● The device must be OFF before you change the working range.
● When starting or operating the device, never touch hot parts such as the exhaust,
ignition cables, or spark plug.
● After the device has stopped, the exhaust pipe is still hot. Never place the device
near inflammable materials (dry grass, flammable gases or liquids, etc.).
● Pay particular attention to the fact that the ground may be slippery when operating
the device in the rain or immediately after the rain.
● If you slip or fall to the ground, release the throttle immediately.
● Be careful not to drop the device or hit it against obstacles.
● Before adjusting or repairing the device, make sure that the device is stopped, and
the spark plug connector is removed.
● Before removing blockages, stop the device and remove the spark plug connector.
● If the device is to be stored for an extended period, drain the fuel from the fuel tank
and carburetor, clean the parts, place the device in a safe place and ensure that the
device has cooled down completely.
● Perform constant checks to ensure the safe and efficient operation of the device.
● Keep the device away from fire or sparks.
● Be careful when using the device. There is a risk of kickback and recoil.
● Use extreme caution when using this device with the cutting blade. A cutting blade
kickback is a reaction that can occur when the rotating cutting blade hits an object that cannot be cut.
This contact causes the cutting blade to stop for a moment and then suddenly repels
from the hit object with accelerated force. This kick-back reaction can be severe
enough that the operator loses control of the device. A cutter blade kickback can
occur without warning if the cutter blade encounters an obstacle, becomes blocked
or jams. This is more likely in areas where it is difficult to see the material being
cut. For easy and safe cutting, approach the weeds to be cut from your right to your
left side. If an object or stick of wood is hit unexpectedly, this can reduce a cutter
64