BaByliss PRO 4rtists LO-PROFX FX726E Bedienungsanleitung Seite 9

Step 2 – Slide the zero gap tool
over the gold fi xed blade until it
is tight against the back portion of
the moving cutting blade.
Step 3 – Using your fi ngers on
each side of the zero gap tool,
push up until the cutting blade
is even with or slightly below the
fi xed blade.
Be sure that the blades are aligned
properly. The teeth of the smaller
blade (cutter) should rest slightly
below the upper edge of the lar-
ger blade (comb) — approxima-
tely 0,5 mm to 1 mm apart (see
Fig. 3). If the blades are not correc-
tly aligned, they may cut or scratch
your skin when trimming. Once
the blades have been aligned, ti-
ghten the screws fi rmly.
Comb (large blade)
Fig. 3
Cutter (small blade)
0.5 mm - 1 mm
Step 4 – MAKE SURE THE MO-
VING CUTTING BLADE DOES
NOT EXTEND PAST THE FIXED
BLADE. WARNING: IF THE CUT-
TING BLADE EXTENDS PAST THE
FIXED BLADE IT CAN POTEN-
TIALLY CUT THE CLIENT.
Step 5 – Once the blade is adju-
sted to zero gap or your liking,
gently tighten the two screws on
each side of the blade while hol-
ding the zero gap tool in place. If
the blade is not adjusted to satis-
faction after testing, repeat the
adjusting process. adjusting process.
DISPOSAL
BATTERY
This trimmer has a lithium-ion bat-
tery. To protect the environment,
this battery should be removed
and properly disposed of when
the unit is no longer operating.
9
OF LITHIUM-ION