Wolf Garten Robo Scooter 3000 Originalbetriebsanleitung Seite 76

If you do have Sub-Zone(s):
Scroll to select
3.3.9 Going to Sub-Zone 1
Robomow will follow the Perimeter Wire around the edge
towards the Sub-Zone.
3.3.10 Press STOP at Zone Entry
P When Robomow is at least 5 m (16 ft.) inside that Sub-Zone
– Press Stop to learn the distance from the Base Station to
Sub-Zone Entry.
Scroll to select the approximate Area of the
Sub-Zone Press
If you don't have an additional Sub-Zone:
P Choose the
mark and press
If you do have another Sub-Zone(s):
P Choose the
mark and repeat the Sub-Zone procedure
(
See Section 3.3.8
Scroll to select
Press
3.4 After Setup is Complete
Once the wire setup is complete, you can drive additional pegs at a
distance of approximately 1 m (3.3 ft.) between them.
P Use additional pegs in areas where there are bumps or dips in
the lawn.
If needed, purchase extra pegs.
P Inspect the wire installation for tripping hazards.
From this point on Robomow is ready to be charged.
Once fully charged it will automatically mow your lawn.
76
mark. Press .
.
.
).
mark.
.
19
Preparing Robomow
S T O P
en