Cleaning And Maintenance; Technical Data - Hyundai 56621 Bedienungsanleitung

Fitting polishing covers (fig. A)
The machine is supplied with a fine and a
coarse polishing cover. The coarse cover
is used to apply polishing paste, the fine
cover to polish it up.
• Put the machine on a table with the polishing
wheel (3) pointing up.
• Pull the polishing cover (9) over the polishing pad
(8) .
The polishing cover should sit firmly en
evenly on the polishing wheel.
SWITCHING ON AND OFF (FIG. A)
1. Press the safety switch (2).
2. Press the on/off switch (1) to turn on the
machine.
3. Release the on/off switch to turn the machine off.
Adjusting the speed (fig. A)
This machine has been fitted with an adjustment
wheel for the maximum speed.
• Turn the adjustment wheel (5) to set the required
speed.
Polishing
• Fit the coarse polishing cover.
• Evenly apply the polishing paste over the surface
of the polishing cover.
• Hold the polishing wheel to the surface to be
polished and switch on the machine.
• Move the machine evenly over the surface to be
polished, without applying pressure.
Always switch off the machine before taking the
machine from the surface.
• After polishing the whole car, remove the coarse
polishing cover from the polishing wheel and fit
the fine polishing cover.
• Polish up the polishing paste, in the same way
and order as you applied it.
Tips for optimum polishing
• Wash the car at least once every two weeks.
Always start at the top and work your way down.
• Polish the car 2 or 3 times per year.
• First polish the large surfaces (such as the roof
and bonnet), then the smaller surfaces (such as
the doors). Polish confined parts by hand.
• Always use clean polishing covers.

CLEANING AND MAINTENANCE

The machine does not require any special
maintenance.
• Regularly clean the ventilation slots.
• Regularly wash the polishing covers. Wash them
by hand only and leave them to dry in the air.
• If you are not going to use the machine for an
extended period of time, remove the polishing
cover from the polishing wheel. Store the
machine with the polishing wheel pointing up.

TECHNICAL DATA

Mains voltage
Mains frequency
Power input
Polishing orbits
Diameter polishing wheel
Weight
Noise and vibrations
L (sound pressure)*
pA
L (acoustic power)**
WA
Vibration value a ***
h
Measuring inaccuracy:
* Uncertainty K =
** Uncertainty K=
*** Uncertainty K =
The sound levels stated are emission levels; they
are not necessarily safe working levels. Even though
the measured values are related to exposure levels,
this information does not allow to determine if
additional measures are required.
Factors that can affect the radiated levels are
duration of exposure, the characteristics of the
work area and other sound sources, as well as
the number of machines of the same type or other
machines in the work area.
The acceptable exposure levels may differ according
to the country of use.
This information is only intended to help the user
assess possible risks.
Wear hearing protection!
ENGLISH
V~ 230
Hz 50
W 1200
min 500-3000
-1
mm 180
kg 2.7
dB(A) 95
dB(A) 106
m/s 8.32
2
dB(A) 3.0
dB(A) 3.0
m/s 1.5
2
9