Vitek VT-3539 Die Betriebsanweisung Seite 5

6. The temperature and humidity readings will appear on the display.
7. Switch from
After these remote sensor settings have been completed, it will begin to transmit
weather data once per minute.
• If your meteorological station registers signals from neighboring sources, choose a
different house code.
• Factory default settings: house code = 01, channel = 01
Step 2: Receiver settings
SYNCHRONIZING THE OUTDOOR TEMPERATURE READING
Auto-detect function:
Manual learning function (Search for remote sensor signals):
If a new sensor is added or if the signal is lost from an existing sensor (the outdoor tem-
perature on the display will blink), the detection function must be completed again.
35391.indd 5 35391.indd 5
All manuals and user guides at all-guides.com
°F to °C by pressing the C/F button.
8. Remove the lid from the battery compartment and, ac-
cording to correct polarity, install two AA batteries. Close
the battery compartment lid.
1. After installing batteries in the receiver, activate the auto-
detect function, which should take about 3 minutes.
2. During these 3 minutes, the receiver will emit an audible
signals and display it once received the data from sensors.
• If no signal is received during the 3 minutes, the outdoor
temperature will be displayed as "- - -". If this happens,
try installing all of the units closer together, or in different
places; run the auto-detect function again – remove the
batteries from the receiver and then insert them again.
5
ENGLISH
23.05.2006 17:08:51 23.05.2006 17:08:51