Operation; General - Hatco MDW-Serie Installations- Und Bedienungshandbuch

OPERATION

General

Use the following procedures to operate a Mini Display Warmer.
WARNING
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
Startup
1. Plug the unit into an electrical outlet of the correct voltage,
size, and plug configuration. See the SPECIFICaTIONS
section for details.
2. Move the Power On/Off (I/O) switch to the On (I) position.
The switch will illuminate.
BURN hAzARD: Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
3. Set the Temperature Control to the desired level between
MIN and MaX.
4. allow 30 minutes to preheat, check the interior
thermometer and adjust the Temperature Control if
necessary.
NOTE: Temperature settings may vary depending upon product
make-up and consistency. The interior thermometer
displays temperature inside of the cabinet, not the food
product temperature.
Shutdown
1. Move the Power On/Off (I/O) switch to the Off (O) position.
2. Unplug the power cord and allow the unit to cool before
performing any cleaning or maintenance.
CAUTION
Figure 7. Control Panel
8
Interior
Thermometer
Power Switch
Temperature
Control
Form No. MDWCEM-0411