Xylem WTW Cond 3110 Schnellstartanleitung Seite 7

Cond 3110
Setting the cell The cell constant to be set must either be taken from the operating manual of
constant the measuring cell or is printed on the measuring cell.
manually
Measuring the
conductivity
Calibration The calibration interval reminds you to calibrate regularly. After the specified
Int.C
interval ( ) calibration interval (
flashes. It is still possible to measure.
ba75783y03 05/2017
All manuals and user guides at all-guides.com
Press <CAL> repeatedly until
1
Confirm the selection with <ENTER> or <CAL
2
The cell constant that was set last is displayed.
If necessary, press <CAL> repeatedly until a cell constant in the range
3
-1
0.800 ... 1.200 cm
Set the cell constant to be used with < >< >, e.g. 0.846 cm
4
Confirm the selection with <ENTER>.
5
The new cell constant is used from now on.
The meter switches to the measured value display.
Immerse the conductivity measuring cell in the test sample.
6
If necessary, scroll with <M> until the measured parameter
7
unit mS/cm or µS/cm is displayed.
Wait for a stable measured value.
8
The [Auto] display indicator flashes as long as the measured value is not
yet stable.
Int.C
) has expired, the symbol for the calibration evaluation
Open the menu for measurement settings with <M
1
Confirm all settings with <ENTER> until
2
Set the calibration interval with < >< >.
3
Confirm the setting with <ENTER>.
4
USE CELL
is displayed.
is displayed.
Int.C
EN
English
_
>.
-1
.
with the
_
>.
is displayed.
7