Connecting Devices; Turning On The Device - Geutebruck G-ST 6000+ G2 Installationsanleitung

G-ST 6000+G2

Connecting devices

All connections are made on the back. In addition, two USB ports are available on
the front.
Please note the following precautions for your security and the safety of the appli-
ance.
Warning!








Turning on the device

Before turning the unit on, please observe the following safety information.



To turn on the device, follow these steps:
1.
2.
3.
4.
All connection work may only be performed when the device is shut off.
Do not remove the cover! Only maintenance-free components are to be found
inside the device. Repairs may only be performed by qualified specialists.
For use of external USB devices, check the order of driver installation and con-
necting of the device.
For all control lines, only use shielded cable. Twist the cable shield at the end
and solder it to the frame of the SUB-D connection (plug or socket).
Do not short-circuit wires with the cable shield. Slide an insulator across the
shield to prevent short circuits.
Do not connect a cable shield to a ground connection (pin).
Keep the twisted part of the cable shield in the plug (socket) as short as possi-
ble.
Use a socket with a protective contact for connection.
Ensure a power supply between 110 VAC and 230 VAC.
Please do not press any keys while powering up!
The operating system is precisely pre-configured for your device. By pressing a
key during powering up, this configuration could be adversely affected.
Connect the device to the power supply
Activate the on/off switch on the power supply unit on the back of the device.
The device has been switched on.
Wait until the operating system has started up and the Begin Registration win-
dow is displayed. During this operation, the client and the database of the de-
vice are started automatically.
Use the key combination Ctrl +Alt +Del to log on MS Windows.
15
Back to the
table of contents