Changing A Redundant Power Supply - Geutebruck G-ST 6000+ G2 Installationsanleitung

G-ST 6000+G2

Changing a Redundant Power Supply

A power supply could be removed when system is off, but also when system is run-
ning (Hot Plug). This only should be done in case of a power supply failure.
Remove the power cord
 Press the locking lever downwards.
 Pull firmly on the power supply handle to remove
 Insert the plug-in module into the system. Push the module as far as possible
into the enclosure. Close the locking lever to arrest the plug-in module.
from the back of the power
12
Back to the
table of contents
supply.
it.