DERMAVIT Diamond Shield IE Crystal Bedienungsanleitung Seite 52

Configuring the AutoStart function
The device can be configured to switch on automatically at a configured time and
execute a sequence. There are two separate auto-start configurations allowing
two different sequences to be executed automatically at different points of time.
The corresponding configuration menu can be reached as follows:
1. Select the menu item Configurat. from the Main menu and press the OK
button.
2. Make sure that the correct time of day is set in the configuration menu.
2. Select either the menu item AutoStart1 or AutoStart2 and press the OK
button.
The configuration menu has the following entries:
•
Message: The auto-start function can immediately begin executing the
configured sequence or it may first display a prompt that is connected
with an alarm signal. The input is done with the arrow keys left and
right.
•
Time: Time of the auto-start feature. The left and right arrow keys change
the hours or minutes. The OK button switches back and forth between
hours and minutes.
•
Run every: The auto-start function can be configured so that it is not
carried out every day, but e.g. every other day or every third day up to
every 7th day. The input is done with the arrow keys left and right.
•
Start: If the auto-start function is not configured for each successive day,
you can set the first day of execution - depending on the above configu-
red interval. The selection between today+1,2,3 up to 7 is done with the
arrow keys left and right.
•
Start from: If a chip card is inserted, you can specify, whether the auto-
start sequence is on the chip card or whether it is in internal memory. The
input is done with the arrow keys left and right.
•
Sequence: The desired sequence from the Standard menu or from an
inserted chipcard can be selected. The input is done with the arrow keys
left and right.
All manuals and user guides at all-guides.com
Diamond Shield IE Crystal
Instruction Manual
page 52