Cleaning And Maintenance; Device In Standby; Problems, Causes, Solutions - Stalgast 830130V02 Bersetzung Der Original Bedienungsanleitung

2. Select the desired parameter. Press "SET" to display its value
3. Change the value with the
4. Press "SET" to confirm the entered value and move on to the next parameter.
To finish: simultaneously press SET+
Note: The value is stored even in case of exit after 15 seconds idle.
7.6. Locking the keyboard
1. Press and hold for at least 3 seconds the buttons and.
2. An „OFF" message will appear indicating that the keypad is locked. Pressing a button for more than 3 seconds will cause the
OFF message to appear.
7.7. Unlocking the keyboard
Press the buttons and hold for at least 3 seconds the buttons
7.8. Alarm
Alarm Cause
„P1"
„P2"
„HA"
„LA"
"EA"
"CA"
"dA"
CAUTION! In the event of the errors mentioned above, contact the service immediately and provide the

8. CLEANING AND MAINTENANCE

8.1. Cleaning
Before first use, clean the appliance and all its accessories. Clean the walls and the inside of the appliance with an antibacterial
agent. Clean the plastic parts with a damp cloth and then dry them. Do not use liquids or chemicals containing abrasives. Wear
protective gloves.
8.2. Periodic cleaning of the compartment and condenser
Before starting any cleaning on the unit, disconnect the device from the power supply. Clean the inside of the appliance at least
once a week by following the instructions in „Cleaning".
For best results, clean the condenser chamber at the top of the machine. Clean the chamber with a brush or a vacuum cleaner.
It is recommended to clean the condenser filter every two weeks. Remove the filter as shown on the picture, clean the condenser
with a brush or vacuum cleaner, and place the cleaned filter in the same place.

8.3. Device in standby

If you do not intend to use the unit for an extended period of time, please take the following precautions:
• Remove the products from the chamber
• Cut off power supply
• Thoroughly clean the appliance
• Ventilate the chamber

9. PROBLEMS, CAUSES, SOLUTIONS

Minor malfunctions may be caused by breakdowns of the mains or faults that may normally be removed without the manufac-
turer's intervention. Before calling for maintenance, please read the following information:
and/or
AUX
or wait 15 seconds without pressing buttons.
+ AUX
+
+
+
+
+
Room sensor error
Evaporator sensor error
Maximum temp. alarm
Minimum temp. alarm
External alarm
Serious external alarm
Opening the door
.
and , the „on" message will.
AUX
Outputs
Compressor output depending on „Cy" and „Cn"
+
Defrosting completed by timeout
Outputs without modifications
+
Outputs without modifications
+
Outputs without modifications
Disable all outputs
Restarting the compressor and fan
alarm symbol.
- 17 -