Herunterladen Inhalt Inhalt Diese Seite drucken

Resetting The Access Point; Resetting And Deleting The Entire Installation - HomeMatic IP HMIP-HAP Montage- Und Bedienungsanleitung

Access point homematic
Vorschau ausblenden Andere Handbücher für HMIP-HAP:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Restore factory settings
7.1

Resetting the Access Point

To restore the factory settings of the Access Point, please
proceed as follows:
Disconnect the Access Point from the power
supply. Therefore, unplug the mains adapter.
Plug-in the mains adapter again and press and
hold down the system button for 4s at the same
time, until the LED will quickly start flashing
orange.
Release the system button again.
Press and hold down the system button again for
4 seconds, until the LED lights up green. If the
LED lights up red, please try again.
Release the system button to finish the procedure.
The device will perform a restart and Access Point is
being reset.
7.2
Resetting and deleting the entire
installation
During the reset, the Access Point must be con-
nected to the cloud so that all data can be dele-
ted. Therefore, the network cable must be
plugged in during the process and the LED must
light up blue continuously afterwards.
To reset the factory settings of the entire installation, the
40

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis