Activating/Deactivating The Power Thresholds - Gewiss CHORUS P-Comfort GWA9916 Programmierhandbuch

C
OMMAND LOAD MANUALLY
Allows the load to be tripped/reconnected manually by sending the corresponding
command on the Load x - Slave switchover communication object, as if it were performed
locally on the load (so subject to the "manual priority" parameter of the active power
threshold, which therefore generates new tripping of the load if the load must be tripped).
The value displayed corresponds to the command that will be sent, and not the status of
the load
VALUES: On, Off; default value opposite that of the load current status
Local relay parameters:
NB:
The parameters are visible if the related enable local change ETS parameter has been enabled
N
OMINAL LOAD ABSORPTION
Allows the nominal absorption of the load connected to the local relay to be set.
VALUES: from 0.01 kW to 6.00 kW with step of 0.01 kW for fine regulation/0.10 kW for
rapid regulation, 0.80 kW (default value)
L
OAD PRIORITY
Allows the priority of the load connected to the local relay to be set.
VALUES: from "1" =max (default value) to "11" =min with step of 1
C
ONSIDER LOAD ABSORPTION BEFORE RECONNECTING IT
Allows the behaviour of the device during assessment of reconnecting the load connected
to the local relay to be defined.
VALUES: Yes (1, default value), No (0)
C
OMMAND LOAD MANUALLY
Allows the local relay to be tripped/reconnected manually, as if acting (at the level of priority
among functions) on the load control function of the local relay.
The value displayed corresponds to the command that will be sent, and not the status of
the load
VALUES: On, Off; default value opposite that of the load current status

Activating/deactivating the power thresholds

The number of the threshold is indicated at the top of the display, the activation ("On") or deactivation
("OFF") status at the bottom.
When the power threshold is exceeded, the
corresponding threshold; the symbol turns off when the power value drops below the threshold value
minus the set hysteresis.
The five different power thresholds (t1...t5) can be activated and deactivated locally.
To activate/deactivate one of the five power thresholds:
pag. 24
All manuals and user guides at all-guides.com
:
1 min inactivity
:
:
:
symbol is on constantly on the display page for the
: