Texas Power Split 540H Betriebsanleitung Seite 18

5. Clean the oil stick (10) and insert it in the fuel tank in order to make sure that the oil
level is between the two marks on the oil stick.
6. Clean the oil stick (10) and O-ring (11) thoroughly and reinstall. Be careful not to
damage the threads of the aluminium oil cover (15).
Recycling:
Make sure to dispose the dirty oil properly. Bring it to your local waste oil recycling centre.
Never dump it on the ground or mix it with trash.Waste electrical products must not be
disposed of with the household waste.
This tool should be taken to your local recycling centre for safe treatment
Refilling of hydraulic oil
 Please inspect the oil level periodically. The level must be in between the
two markings on the oil stick. If the oil level is too low, you shall refill by using
recommended oil.
Sharpening the wedge
 After long periods of operation and when it is required, you must sharpen the wedge by
using a fine-toothed file and carefully remove any burrs or flat spots on the wedge.
18