Blade Maintenance - VonHaus 20V MAX Bedienungsanleitung

BLADE MAINTENANCE

WARNING! Always wear gloves when handling or cleaning the Dual Action Cutting Blades.
Always clean the Dual Action Cutting Blades after
operation and coat with lubricating oil or spray.
This will prevent the Blades from becoming seized or
corroded during storage.
During longer cutting periods of 15 mins or longer,
it is recommended that you lubricate the Blades in
order to improve cutting performance.
A lack of lubrication can severely effect the products
run time and may cause the blade to overheat.
Before use, visually check the condition of the cutting
edges of the Cutting Blades and check the tightness
of the bolts.
When not in use, ensure the Cutting Blades are
covered with the Safety Guard provided and that they
have been lubricated.
Failure to do so may cause the Blades to corrode and
will severely reduce cutting performance and Battery
run times.
TROUBLESHOOTING
PROBLEM
TOOL DOES NOT POWER ON.
BLADES DO NOT MOVE.
POOR CUTTING PERFORMANCE.
BLADES BECOME HOT.
BLADES JUDDERING OR VIBRATING
ABNORMALLY.
11
SOLUTION
Check that the Battery is connected correctly.
Check that the Battery is fully charged before use.
Ensure that the Charger is charging correctly.
The Blades may be blocked. Power off and remove the
blockage.
The Blades may have seized. Contact DOMU Brands
Customer Services.
The Blades may be damaged. Contact DOMU Brands
Customer Services.
The Battery may be low, remove the Battery and recharge.
The Blades have not been lubricated. Power off the tool and
remove the battery, then lubricate the Blades as necessary.
There is a blockage. Power off the tool and remove the
blockage.