Werbung
ENGLISH
1 Loosen
2 Tighten
3 Hold
4 Wing nut
5 Spring washer
6 Flat washer (small)
7 Base
8 Flat washer (large)
9 Bolt
10 Trimmer shoe
11 Adjusting screw
12 Scale
13 Bit protrusion
14 Nut
15 Graduation
16 Wing bolt
17 Amount of chamfering
18 Switch lever
19 Workpiece
20 Feed direction
SPECIFICATIONS
Model
Collet capacity ..................................... 6 mm or 1/4''
–1
No load speed (min
) ................................... 30,000
Overall length ............................................... 310 mm
Net weight ....................................................... 1.5 kg
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Power supply
The tool should be connected only to a power supply
of the same voltage as indicated on the nameplate,
and can only be operated on single-phase AC supply.
They are double-insulated in accordance with Euro-
pean Standard and can, therefore, also be used from
sockets without earth wire.
Safety hints
For your own safety, please refer to the enclosed
safety instructions.
ADDITIONAL SAFETY RULES
1. Hold tool by insulated gripping surfaces when
performing an operation where the cutting
tools may contact hidden wiring or its own
cord. Contact with a ''live'' wire will make
exposed metal parts of the tool ''live'' and
shock the operator.
2. Wear hearing protection during extended peri-
ods of operation.
3. Handle the bits very carefully.
4. Check the bit carefully for cracks or damage
before operation. Replace cracked or dam-
aged bit immediately.
5. Avoid cutting nails. Inspect for and remove all
nails from the workpiece before operation.
8
Explanation of general view
21 Bit revolving direction
22 (View from the top of
the tool)
23 Correct bit feed direction
24 Trimmer shoe, straight guide
or trimmer guide
25 Bolt
26 Guide plate
27 Straight guide
28 Flat washer
29 Wave washer
30 Wing nut
31 Clamp screw (A)
32 Center hole
33 Nail
34 Adjusting screw
35 Clamp screw (B)
36 Trimmer guide
37 Bit
6. Hold the tool firmly.
3704
7. Keep hands away from rotating parts.
8. Make sure the bit is not contacting the work-
9. Before using the tool on an actual workpiece,
10. Be careful of the bit rotating direction and the
11. Do not leave the tool running. Operate the tool
12. Always switch off and wait for the bit to come
13. Do not touch the bit immediately after opera-
14. Always lead the power supply cord away from
15. Do not smear the tool base carelessly with
16. Draw attention to the need to use cutters of the
ENB054-1
SAVE THESE INSTRUCTIONS.
38 Guide roller
39 Screws
40 Screwdriver
41 Templet guide
42 Convex portions
43 Straight bit
44 Templet
45 Distance (X)
46 Not available
47 Not available
48 Not available
49 Not available
50 Not available
51 Not available
52 Not available
53 Not available
54 Not available
55 Limit mark
56 Brush holder cap
piece before the switch is turned on.
let it run for a while. Watch for vibration or
wobbling that could indicate improperly
installed bit.
feed direction.
only when hand-held.
to a complete stop before removing the tool
from workpiece.
tion; it may be extremely hot and could burn
your skin.
the tool towards the rear.
thinner, gasoline, oil or the like. They may
cause cracks in the tool base.
correct shank diamater and suitable for the
speed of the tool.
Werbung
