Info; Standalone Mode - JB-Lighting A8 Bedienungsanleitung

COOLING MODE
The A8 offers three different modes for fan opperation. The default setting
suit most applications. Switch to
This mode is to be used only a well ventilated rooms with low ambient temperature, with
reduced light output or if the fixture is only required occasionally. The
designed to be used in areas with higher air temperature or for fixed installtions. The fans
start to run faster with more airflow which produces more noise.
There is in no mode danger for the lifetime of the A8. If the temperature rise to
much the fixture switches off automatically.
WLJB DMX HOLD
The behavior of the A8 incase the wireless DMX connection is interrupted can be set to:
1. DMX Hold - A8 freezes on the last received DMX value.
2. Fade out - A8 fades out after 5 seconds.
When DMX signal is back the A8 first turn to his new position and fades in.

4.5 INFO

The menu informs about the current software/firmware version. The non-resettable
TOT OPERATE TIME
Temperature readouts from the display panel (
TEMP BASE PS
(
TEMP HEAD LED
(
temperature and the maximum temperature reached since the readout was last reset
individually.

4.6 Standalone mode

A sequence, up to 20 steps, consisting of preprogrammed cues can be recalled by means
STANDALONE MODE
of the
different ways. The first way is to program every feature by means of the key of the units
onboard control panel. The second way is to program the cues by means of a connected
DMX control console and to store them in the fixture.
IMPORTANT !
The functions
nation of keys and not just by pressing "ENTER". Before activating the functions make
sure that there is just one DMX-transmitter in the DMX-line (e.g. one controle console or
one master fixture). A number of DMX-transmitters can damage the DMX driver of the
fixtures. To enter the functions press "ENTER" (keep it down) and press "ESC" in addition.
Programming the standalone sequence:
Enter the menu
STEP NR 01/01
MODIFY
Enter the
enter DMX values.
FADE TIME
Enter
NEXT TIME
which will be the duration of the step.
Add a new step with
to the new step.
28
SILENT
counter displays total hours of use since the A8 was manufactured.
) in the base as well as the driver (
) in the head are available. In each case, you can view the current
. The sequence will run as a loop. Cues can be entered in two
MODIFY RUN
, and
STANDALONE, EDIT.
will be displayed.
menu to get access to the fixtures functions. Recall the functions and
(during which the effects will move to the programmed position) Enter
INSERT.
The DMX values of the last step will be automatically copied
to reduce the speed of the fans to a minimum.
TEMP BASE LCD
TEMP HEAD DRV
REMOTE
can be accessed only by pressing a combi-
STANDARD
HI POWER
mode is
) and power supply unit
) and LED PCB
will