Zaddox RXS Montageanleitung Seite 4

Installation instructions – Display settings
(1) Toggle between total kilometre counter (TOTAL), trip kilometre counter (TRIP):
Short press the SET button
(2) Clear trip odometer:
Press the ADJ button for 4 seconds in the TRIP interface
(3) Setting the metric:
(1) Long press on the SET button until the speed indicator flashes
(2) Press the ADJ key to switch between the systems (km/h / mph)
(3) The settings are saved when no adjustment is made for more than 15 seconds.
(4) Setting the time: (after setting the metric)
(1) Open the time setting:
Short press on the SET setting button in the metric setting to switch to the clock setting
(2) Toggle from hours to minutes:
Short press on the SET key
(3) Adjust hours / minutes by 1:
Short press on the ADJ setting button
(4) The settings are saved when no adjustment is made for more than 15 seconds.
(5) Reset of the oil light: (Lights up every 2000 km as a reminder to change the oil.)
Pressing the ADJ setting button for 4 seconds in the TOTAL interface.
Electrical terminal assignment
black
-
Low beam
red
-
Battery
light
blue
-
Turn
right
green/
blue/red
blk
-
Gear 3
grey
-
Gear 6
Setting range of the resistance for the water temperature gauge
Temperature (°C)
Resistance (Ω)
blue/
green
yellow
-
-
negative
Fuel
blk/red green/red
- -
Idle N
RPM
blue
orange
-
-
High
Turn left
beam
pink
- -
Gear 2 Gear 1
yellow/
yellow/
white
red
-
-
Gear 5
Gear 4
60 90
557 196
Color
brown / red
green / white
red/
white
-
Sensor
+
100 120
136 80
Function
Engine failure
Water temperature
yellow/
blk/white
green
-
-
Sensor
Sensor
signal
-
Page 2/2