Zaddox RXS Montageanleitung Seite 3

LCD Speedometer Zaddox RXS
Display options / Technical data
Idle N
Time
High beam
Turn
left
Gear
Setup button
SET
Installation instructions – Basic settings
Turn on and open the user interface for the basic settings
Long press the setup button SET and open the electric door lock (Default: 018 12)
Switch to the next setting / unit by holding the setup button SEL.
Increase a selected unit (+1) by shortly pressing the setup button SEL.
Basic settings:
(1) Wheel settings (018: 18 Hz
(1) Formula: Calibration figure = 1000 / wheel circumference x amount of magnets / 60
E. g. 110/70-R17 (wheel circumference = 1,86 m) with 2 magnets: 1000 / 1,86 x 2 / 60 = 17,91 ~ 18
(2) Press and hold the setup button SEL to change from ones digit to tens, hundreds or thousands.
(2) Fuel settings
≙
(1) 1 Two-pipe-system
(2) 5 ≙ Three-pipe-system
(3) RPM setting
(1) 2 ≙ 166 Hz ≙ 10 x 1000 r/min
(2) 4 ≙ 333 Hz ≙ 10 x 1000 r/min
Finally, press and hold the setup button SET to save the settings.
Mounting Instructions
General Information
Thank you for purchasing a Zaddox speedometer.
Please read the following installation instructions carefully.
Motea GmbH accepts no liability for damage to property and/or personal
injury resulting from improper or faulty installation or use.
Please check the correct function before each use.
Retighten the screws if necessary.
The installation requires knowledge of motorcycle electrics. In case of
doubt, the speedometer should be installed by a specialized workshop.
Subject to technical changes, printing errors and mistakes.
Kontrollleuchten
RPM
Velocity
Odometer
≙ 60 km/h)
Technical Data
Operating voltage:
Turn
right
Metric system:
Velocity indicator:
RPM:
Odometer:
Trip-Odometer:
Fuel
Time:
Fuel:
Setup button
Calibration
ADJ
Speed:
RPM:
12 V DC
Kilometre / Mile
0-199 km/h / mph
0~13000 r/min
0-99999,9 km / miles
0-999,9 km /miles
12 h
6-stufig
18 Hz ≙ 60 km/h
166 Hz ≙ 10 x 1000 r/min
Page 1/2