Operating Elements And Connections - Omnitronic XIRA-215A Bedienungsanleitung

3 Operating Elements and Connections

No. Function
1 Status indicators
POWER: speaker is powered on
CLIP: the signal level is too high; the limiter
will reduce the signal level to protect the
speakers. Reduce the volume with the
master control until the LED does not light
anymore, or only at signal peaks.
SIGNAL: input signal is present
2 DSP PRESET control
To select various equalizer presets: MUSIC =
low and high frequency boost, DJ =
increased presence and bass, MONITOR =
low and mid frequency reduction around
2 kHz, SUB = low frequency cut for
applications with a subwoofer.
3 MIX OUT jack
XLR output of the master signal of both
channels for connection to a line input of a
further active speaker or to a mixer or
amplifier.
4 CH 1 line input with volume control
Combo
connecting audio units with line level output
(e.g. CD player). Use the volume control to
mix the signal to the master signal.
5 CH 2 mic/line input with input selector
switch and volume control
Combo
connecting microphones or audio units with
line level output (e.g. CD player, mixing
console or music instrument). Engage the
input selector
disengage the selector for line level. Use
the volume control to mix the signal to the
master signal.
6 Power input with fuse holder
Used to plug in the supplied power cord.
Only replace the fuse when the device is
disconnected from mains. Only use fuses of
the same rating and power. The correct
fuse value is specified on the rear panel.
7 Power switch
Turns power to the speaker system on and
off.
12 • EN
input (XLR/6.3 mm
input (XLR/6.3 mm
for microphone
jack) for
jack) for
level,