Connecting Machine To Power Source; How To Choose Your Pattern - VERITAS MyJanis Kurzanleitung

Connecting machine to power source

1
2

How to choose your pattern

EN
A
1
2
Attention!
Always make sure that the machine is
unplugged from power source and the
main switch is on („O") when the machi-
ne is not in use and before inserting or
removing parts.
Before connecting the power supply, make sure
that the voltage and the frequency shown on the
rating plate conform to your mains power. Place
the machine on a stable table.
1. Connect the machine to a power source as
illustrated.
2. Turn on the power switch.
3. The sewing lamp will light up when the
switch is turned on.
With the sewing machine turned off, insert the
foot control plug into its connector on the se-
wing machine.
Turn on the sewing machine, and then slowly
depress the foot control to start sewing. Release
the foot control to stop the sewing machine.
Please Note:
Consult a qualified electrician if in doubt as to
connect the machine to the power source.
To select a stitch, simply turn the pattern selector dial. The pattern selector
dial may be turned in either directions.
For straight stitch, select pattern "
For zigzag stitch, select pattern "
(1) Pattern selector dial
(2) Reverse lever
Please visit our website www. veritas-sewing. com/janis.
There you will find a detailed description of the individual
stitch programs, in the instruction manual.
16
" with the pattern selector dial.
" with the pattern selector dial.