TESY CN 031 EI CLOUD AS W Bedienungs Und Aufbewahrungsanleitung Seite 15

3. Without generation of ozone, hydrogen peroxide, organic or inorganic
molecules or ions
4. High degree of reduction of bacteria and fungi
5. Extremely long service life - over 50,000 hours (over 12 years).
6. Quite working mode – natural air flow, through the convector heater
Principle of work of Air safe function
The Air Safe function can be switched on and off by the user through the
convector control menu. In order to work, it is necessary the convector to
be switched on and heated (the set temperature is higher than the ambient
temperature).
When the temperature of the heater rises, the natural air flow starts in the
room.
Colder air enters through the lower openings of the convector and passes by
the UVA LEDs.
Due to this movement, the molecules of gases, bacteria, micromycetes (fungi)
and other microorganisms contained in or carried by the air are irradiated by
the combined effect of UVA LED radiation and the infrared radiation of the
heater. The continuous passage of the air flow through the volume of the
convector provides enough energy to break the connections supporting the
structure of harmful microorganisms carried by the air.
As a result of natural convection, after a certain period of time, the air
contained in the room completely passes through the volume of the
convector, which leads to a reduction of the bacteria and micromycetes
contained in it.
Function Air Safe is a protection against harmful organisms such bacteria and
fungi. Provides better air hygiene and benefits to а healthier environment.
The function can be switched Off manually.
Activation and deactivation of Air Safe function - /Quick start B11/
Operation of Air Safe must continue for 2 minutes after stopping the heating
element, and then turn off.
Built in tip-over switch /Quick start B12/– if the convector tilts with more
than 45° or falls down, the power must switch Off and indicate on display
''tilt'' . After restoring the device to its normal position, operation of the last set
function must continue.
Function Wi-Fi – only for models CN 051 xxx EI CLOUD AS W, CN 051 xxx
EI CLOUD W, CN 031 xxx EI CLOUD AS W and CN 031 xxx EI CLOUD W
Function Wi-Fi
Activation and deactivation of Wi-Fi Function and Wi-Fi Local Function - /
Quick start B15/
Work mode of display:
When pressed - backlight intensity - 100%; after 5s – OFF
Sound option
Activation and deactivation of sound function - /Quick start B14/
Device info
Visualization on Display in "Device info" /Quick start B13/
- ID
- MAC address
- Firmware version
Quick menu /Quick start C 1 -5/
Push the "Mode" button to start quick already configured program.
Content function:
- Comfort
- Eco
- Sleep
- Delay start
- Weekly schedule
English
Exit from the any mode – with single pushing of ON/OFF button
Errors mode:
If the display shows "t1" or "t2", this means that the self-diagnostic system has
found a problem with the temperature sensor. "t1" indicates a disconnected
cable at the sensor, while "t2" indicates short circuit at the sensor. In this case
the electric convector will be automatically switched off and it can be switched
on again only after the problem has been fixed. The problem has to be handled
by a qualified specialist.
DISCONNECTION FROM THE POWER SUPPLY:
If the electric convector is disconnected from the mains, this will not affect
the set temperature and the mode of operation which has been active prior
to its disconnection. If for example the convector has been in "Heating" mode,
after it has been disconnected and reconnected to the mains, it will continue
operating in the same mode with the same set temperature.
The principle of operation of the electric convector with energy-independent
memory is to store the settings for 120 minutes guaranteed, and up to 180
minutes not guaranteed.
If the time is more than 120 min the appliance going to Stand by mode.
PROTECTION
• The appliance is equipped with a safety thermo turn-off device, which
automatically turns the heater off in cases of extreme temperature of the
panel heater /i.e. overheating of the appliance/.
• The safety thermo turn-off device will automatically restore the heater
operation when the temperature of the appliance falls below the
permissible ultimate values.
CLEANING
• It is compulsory first to turn off the appliance through its power
switch and to disconnect it from the power socket. Before starting the
cleaning session you should wait until the panel heater cools down in a
disconnected state.
• The panel heater can be cleaned with little efforts at the appliance
rear part – just press the "P"-shaped braces /figure 2/ at the back of the
appliance so that you can dismantle it and consequently you can clean the
rear part of the appliance.
• Clean the heater body with damp cloth, vacuum cleaner or a brush.
• Never immerse the appliance into water – there is danger for your life from
electric shock!
• Never use gasoline, thinner or hard abrasive products to clean the
appliance, because they will damage the appliance coating.
STORAGE
• Before putting the panel heater away let it cool down after you have
disconnected it from the power socket
• Use the appliance original packing to store it, if the panel heater will not
be in use for a long period of time. By storing the product in its original
packing you protect it from excessive dirt and dust accumulation.
• Never put a hot panel heater in its packing!
• It is necessary the product to be stored at a dry and dark place, protected
from direct sun light.
• It is explicitly forbidden to store the panel heater in damp and wet premises.
MAINTENANCE OPERATIONS OF THE APPLIANCE
• In case of appliance malfunction, please contact the authorized service
center closest to your location. /service centers are indicated in appliance
warranty documents/.
• Important: In case of a claim and/or violation of your consumer rights,
please contact the supplier of this appliance at the indicated locations or
via the Internet page of the company: www.tesy.com
DIMENSIONS OF HEATED VOLUME AND HEATED AREA OF A ROOM /
.
Operation and Storage Manual of Panel Heater
EN
15