Description Of The Control System - May Way SPT-60GL Gebrauchs- Und Installationsanweisung

Exchange of the main burner´s nozzle: picture 3
Remove the grid and upper parts of the burner .Screw up the nozzle and screw in the new one for required gas
type - see technical chart.You need not to regulate air feeder. Pay attention to interlock all parts of burner
Regulation of the fl ame by the lower performance (sporo):
Adjust the low performance (sporo) and then regulate the fl ame with screw which is situated in the body of the
tap next to the tap shaft.
Process of regulation:
• remove the regulation tap knob (pull to yourself)
• there is slot for regulation next to the tap shaft
• regulate the fl ame with the small fl at screwer
Important:
After having rebuilt the gas type, change the data on the label.
How to check the operation of the device
• check the gas leaks
• check the ignition and fl ame of the main burner
• check the ignition and fl ame of the main burner for min. performance (sporo)
• check whether the fl ame of the burner licks the thermoelement and whether it is blue
• we recommend to the user when using the device to proceed according to the instructions for use

DESCRIPTION OF THE CONTROL SYSTEM

Ignition of the burner and regulation of the performance : (pictures 1,2)
Turn the regulation knob of the competent burner (A) into position „ignition of the main burner" and then press it
down and hold it. Ignite the burner with lighter or matches. After ignition of the burner hold the knob (A) pressed
several seconds till the thermofuse gets hot. Then release the button. If the fl ame goes out repeat the whole
process once more.
Lower performance sporo: (pictures 1,2)
By turning the knob (A) into position „sporo" you set the burning of the burner for sporo (lower performance)
How to switch the burner off: (pictures 1,2)
Turn the knob (A) into position"0".
Control of the electic oven
Warning!
Before using the machine for the fi rst time, it is necessary to clean it properly with a rag soaked in a solution of
water and detergent. Dry properly after cleaning. Never leave the machine unattended when it is in operation!
Turn control knob C to the right, this turns on the oven fan. This signalled by green indicator E. Using knob C
again, set the desired oven temperature. Orange indicator D signals operation of the heating element and it goes
off when the oven reaches the set temperature. Control knob F is a passive timer, which only rings upon lapse
of the set time, but does not automatically switch off the oven.
Instructions for sucking off the gas products of combustion:
6