Therabody TheraFace PRO Bedienungsanleitung Seite 9

C. Microcurrent Treatment
1. Remove any percussive therapy attachment before attaching the
Microcurrent Ring.
2. Prior to starting the microcurrent treatment, apply the TheraOne™
Conductive Gel to your clean, dry face or treatment area to ensure
the treatment is delivered correctly.
3. Attach the Microcurrent Ring to the TheraFace PRO device.
4. Once attached to the TheraFace PRO, turn ON the TheraFace PRO
device by pressing the Power Button for 2 seconds.
5. Turn on the microcurrent treatment by pressing the ring button once.
6. To adjust the intensity level to your comfort, press the ring button once
to toggle between the 3 intensity options.
7. To stop the microcurrent treatment, press the ring button a third time.
PRO Tip: When using the Microcurrent Ring, slowly glide the device using light
to medium pressure, keeping both spheres on the face at once. A microcurrent
protocol of 5-8 minutes can be completed once per 24-hour period. Be sure to
visit therabody.com for treatment protocols and instructional videos.
Note: • There is a preset shut off time of 8 minutes
• Cannot be combined with the percussive therapy attachments
• While the Microcurrent Ring will work with any conductive gel, we
recommend the TheraOne™ Conductive Gel if available in your market.
Warning: When using the TheraFace PRO with the Microcurrent Ring, a
microcurrent primer is required. Do NOT use the Microcurrent Ring on the midline
of the neck or eye area.
D. Microcurrent Primer: TheraOne Conductive Gel
The TheraOne™ Conductive Gel is a primer intended to be used with the
TheraFace PRO device prior to starting the microcurrent treatment to ensure
the treatment is delivered safely and effectively.
Directions:
1. Start with a clean, dry face.
2. Apply a mask-like layer of the conductive gel to all treatment areas
of the face and neck.
3. Following treatment with the microcurrent ring, rinse off and apply
your favorite moisturizer.
EN
8