Viesta VDI90230EG Gebrauchsanleitung Seite 13

4.3 Press (Increase) button again when it is working on the mid speed, the cooker hood works at
the high speed and the LED display will display "3".
5. ( Decrease) button
Press (Decrease) button, the cooker hood will decrease one speed, and the display will show the
current working speed. When press (Decrease) button again when it is working on the low speed,
the cooker hood will turn off and the backlight of the (Decrease) button will be off.
6. (Timer) button:
6.1 The (Timer) button works when the motor and light is on only. The timer setting is 5mins and
could be repeat setting. When the time is up, the cooker hood will be turn off and the light will be off
Fault
Light on, but motor does not work
Light does not work, motor does not
work
Oil leakage
Lights not working
Insufficient suction
The Cooker hood inclines
NOTE:
Any electrical repairs to this appliance must conform to your local, state and federal laws.Please contact
the service centre if in any doubt before undertaking any of the above.Always disconnect the unit from
the power source when opening the unit.
TROUBLESHOOTING
Possible Cause
Fan switch turned off.
Fan switch failed.
Motor failed.
House fuses blown.
Power cord loose or disconnected.
One way valve and the outlet are not
tightly sealed.
Leakage from the connection of
chimney and cover.
Broken/Faulty globes
The distance between the cooker
hood and the gas top is too far
The fixing screw not tight enough
[ EN ● 13 ]
KEN002DH 24.02.2021
Solution
Select a fan switch position.
Contact service center.
Contact service center.
Reset/Replace fuses.
Refit cord to power outlet.
Switch power outlet on.
Take down the one way valve and seal
with sealant.
Take chimney down and seal.
Replace globes as per this instuction
Refit the cooker hood to the correct
distance.
Tighten the hanging screw and make
it horizontal.
Version: 3.0
.