How To Use Your Air Fryer - HOMCOM 800-114V70 Bedienungshandbuch

If you decide that you do not want to use the preset settings you can set your
preferred time and temperature by using the "
time and temperature.

HOW TO USE YOUR AIR FRYER

1. Place the air fryer on a flat and even surface.
DO NOT PLACE THE FRYER ON A SURFACE THAT IS NOT HEAT RESISTANT.
2. Put the basket in the pan.
DO NOT FILL THE PAN WITH OIL OR ANY OTHER LIQUID.
3. Place the ingredients in the basket and put the basket into the pan, place the pan
into the appliance. The fryer LED should light up.
4. Set your cooking time and temperature by either choosing one of the 7 preset or
manually setting it with the "+" "-" buttons. See "cooking guide" on page 6 to
determine the right time and temperature.
NOTE: When setting the time manually, always add an extra minute or two to the
cooking time to allow the cooker to warm-up.
5. Once you have set your cooking time and temperature, press the power button to
begin the cooking cycle.
Note: To stop the cooking cycle or reset the fryer settings, press the power button again.
A red led flashing indicates that the fryer is beginning the cooking cycle. If there is not
flashing, the cooker will go into standby mode.
6. There are some ingredients that you may need to shake halfway through the cooking
cycle (See "Cooking Guide" on page 6). To do this, pull the pan out of the appliance by
the handle, the air fryer will automatically shut down, and shake the pan or turn the food
items using tongs or a suitable kitchen utensil. Then place back into the air fryer and it
will resume the cooking cycle. the timer will reset to the original setting, so take note of
the remaining time before pulling the basket out of the air fryer.
7. When the cooking time has been reached , the timer will beep 5 times, after the
timer beeps 5 times, the air blower will stop in 40 seconds.
8. Pull the pan out of the fryer and place it on a pot holder.
NOTE: Oil from the ingredients will gather in the bottom of the pan, so be careful when
pulling the pan out of the fryer.
9. Check if the ingredients are ready, if they are not, simply slide the pan back into the
fryer, set your cooking time and temperature, and press power button for start to run
your air fryer.
10. To remove the ingredients, put handle 1 into the basket, hold handle 1 to remove
basket from pan.
NOTE: Do not turn the pan over, the oil collected at the bottom of the pan will leak onto
the ingredients.
11. Empty the contents into a bowl or plate.
TIP: You can remove the basket from the pan our use a pair of tongs to transfer large or
fragile ingredients from the basket.
12. If you would like to prepare more, you can instantly use the air fryer once another
batch of ingredients is ready.
EN
"or " " buttons for the cooking