19 Inch Rack Mount Montage - Genua genuscreen Kurzanleitung

3

19 inch Rack Mount Montage

Optionally, the S Hardware is available with two rack mount brackets. These can be used
to mount the hardware in a 19 inch rack.
1. Use a screwdriver to loosen the two frontal screws on the right and left side of the S
hardware case.
2. Remove the screws and put them aside.
3. Position the rst bracket on the side of the case as seen in gure 9.
4. Attach the rst bracket using the screws that you removed in step 1.
5. Attach the second bracket on the other side of the case in the same way.
6. Insert the S hardware into the 19 inch rack.
7. Screw the two brackets to the rack rails.
Figure 9: S hardware montage
S Hardware Rev 3.0
genua GmbH. All rights reserved. 13