Using The Scooter; Transporting The Scooter - HOMCOM 371-033 Montageanleitung

7.Using the Scooter

Riding
Hold on to the handlebars with both hands, place one foot on the non-
slip tread, and give momentum by pushing off with the other foot.
Brakes
To stop, step on the rear wheel brake
it is fully stationary.

8.Transporting the Scooter

CAUTION!
Risk of injury! There is a danger of crushing. Carefully fold the
scooter. Pay special attention to your fingers.
Only transport the scooter in the folded condition.
The scooter folds easily for easy transport.
1.Loosen the locking lever
metal pin on the steering column
completely into the frame. Secure the steering column
tightening the locking lever
2.Press the metal pins on the handles
steering column. Fasten the handles in the holder
3.Press the button for the folding mechanism
9.Cleaning and maintenance
Clean the scooter with a damp cloth. Do not use solvent-based or abrasive
cleaning agents. Allow the scooter to dry completely after cleaning.
Dry wet or damp ball bearings with a clean cloth. Grease the bearings with
a suitable bearing grease from the outside to prevent rust formation.
Check the scooter for damage and wear before and after use. Self-locking
nuts and other fasteners may loosen due to stress. Check them regularly
and re-tighten them if necessary.
In particular, check the screw connections for tightness and re-tighten the
screws if necessary. If the scooter presents damage, suspend its use. Do
not perform any repairs or structural modifications to the scooter.
EN
. Do not get off the scooter until
on the steering column
and push the steering column
.
, pull the handles out of the
. Press the
by re-
.
and fold the scooter.