hillvert HT-LOGAN-14SA Bedienungsanleitung Seite 39

2. Remove the rubber hoses and the mesh filter inside the tank. Remove the
cap for spraying liquid substances, and install the cap for spraying powder or
granules.
3. Remove the nut with the hole and hose coupling from the outlet opening.
Close the hole with the full nut.
4. Remove the rubber hoses supplying fluid from the tank to the nozzle, the
metering faucet and the sprayer nozzle.
5. Install the chain to avoid an electrostatic discharge that occurs when spraying
powders. Insert the copper piece of the chain into the outlet pipe (take
special care not to allow the copper wire to enter the unit and damage the
pump), screw the clamp onto the clamp connecting the corrugated pipe to
the unit outlet. The chain itself should be freely touching the ground.
REFUELING
1. Place the device on a stable, level surface.
2. Clean the area of the fuel filler cap from any deposits to protect the fuel tank.
3. Unscrew the fuel filler cap.
4. Pour in the prepared fuel/oil mixture. For the proportion of fuel/oil and their
types, see the technical details table.
5. Tighten the fuel filler cap.
Caution: Do not add more oil to the mixture than recommended. It is prohibited to
overfill the fuel tank. If the tank overflows, remove excess fuel immediately by
suctioning it with proper equipment.